Table of Contents
Advertisement
Steps
1. Place the display panel and display assembly on a clean and flat surface.
2. Connect the display cable to the connector on the display panel and close the latch.
3. Adhere the tape to secure the display cable to the connector on the display panel.
4. Turn the display panel over and place the display panel on the display back-cover.
5. Lift the bottom side of the display panel and slide the top side into the slots at the top of the display back-cover.
6. Gently push down on the edges of the display panel until it clicks into the tabs on the display back-cover.
7. Replace the two screws (M2x2) to secure the display panel to the display back-cover and antenna assembly.
Next steps
1. Install the
display
hinges.
2. Install the
display
bezel.
3. Install the
display hinge
4. Install the
display
assembly.
5. Install the
wireless
card.
6. Install the
M.2 2230 solid-state drive
7. Install the
base
cover.
8. Follow the procedure in
Camera
Removing the camera
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
110
Removing and installing Field Replaceable Units (FRUs)
caps.
or the
M.2 2280 solid-state
After working inside your
Before working inside your
drive, whichever applicable.
computer.
computer.
Advertisement
Table of Contents
