Before You Start The Lossnay - Mitsubishi Electric VL-100ZSKRT-E Operating Instructions Manual

Before you start the Lossnay

1. Preparing to turn the power on
Turn the power supply isolator on at the distribution
board.
2. Insert the supplied lithium battery
(CR2025) into the remote controller.
1 Insert a pen tip, etc. into the hole on the back of the
remote controller, and slide it in the arrow direction.
2 Draw out the holder.
3 Place the lithium battery in the holder with the plus
sign (+) facing upward.
4 Push the holder in firmly with the lithium battery in it.
Pen tip, etc.
Remote controller
(back)
Note
- Be sure to place the battery in the holder
before inserting the holder.
- Do not insert a battery other than specified.
- To prevent small children from accidentally
swallowing the battery, the holder is not easily
detached.
- Do not disassemble and modify the remote
controller.
- Do not apply a strong impact to the remote
controller or drop it.
- Do not place anything on the remote controller
or step on it.
- Do not pour water on the remote controller or
place anything wet on it.
- Do not leave the remote controller in places
exposed to direct sunlight or with high
temperatures and humidity.
- The battery is a consumable part.
- Replace the battery about once a year.
- The life of the battery varies depending on the
operating frequency of the remote controller
and the type of battery used.
- Battery power is consumed even when the
remote controller is not used.
- Dispose of the battery according to the local rules.
Apply insulation tape, etc. to the plus [+] and [-]
terminals to insulate them before disposal.
Power supply
isolator
Lithium battery
(CR2025)
①
④ ③
②
Hole
Holder
3. Installing the remote controller holder
Secure the remote controller holder with the
supplied mounting screws.
- We do not recommend that you operate the unit with
the remote controller placed in the remote controller
holder, since the reception sensitivity decreases.
- If you wish to operate the unit with the remote
controller placed in the remote controller holder,
check the position where you can operate the
unit with the remote controller and then install the
remote controller holder.
<Remote controller operation range>
Light receiver
Note
- The remote controller operation range above
shows the case where you operate the unit
with the remote controller pointed toward the
light receiver of the main unit.
- If the sensitivity has decreased, replace the
battery.
- It may not be possible to use the remote
controller in the following locations:
- Location where an obstacle exists between the
main unit light receiver and remote controller
- Location where exposed to strong light from
inverter lighting equipment
- Location where strong light such as direct
sunlight shines on the main unit light receiver
- Location where exposed to electromagnetic
radiation, such as near a television
- When placing a bed, we recommend placing it
within the operation range of the remote
controller.
6
Remote controller holder
mounting screws
Remote controller holder
Main unit
90゜