Operational Check - Harmar Mobility HELIX CSL500 Installation & Service Manual

OPERATIONAL CHECK

Before putting the lift into operation for the user,
verify the following:
 Check all stops (top, middle & bottom)
Footrest obstruction sensor

(both directions of travel)
Rail obstruction sensor

(both directions of travel)
Rail (all hardware and mounting hardware

are tight)

Final limit (both ends of travel)
Seat swivel sensor (lift won't run if seat is

swiveled)
Check all clearances to ensure there are no

pinch points
Provide the Owner's Manual and review the

lift's operation and stops with the customer

Charge for 12-hours after testing is complete
Test wireless remote (in both direction of

travel)
Ensure that all legs are caulked (outdoor unit

only)
Corrosion blocking has been applied to

chassis (outdoor unit only )
Verify that the Overspeed Shipping Bolt was
 removed (the overspeed feature will not
operate with the bolt in place.)
HELIX CURVED STAIR LIFT: SECTION 3
Seat position, level at top and bottom. If it is not
level or customer would like the chair to have a
slight uphill tilt, adjust with the leveling joint.
• Loosen set screw
• Remove shoulder bolt
• Adjust joint in or out depending on which
direction you want the chair to go
• Re-tighten all with Loctite 243
The lift is now ready to use. Remember to leave the
Owner's Manual with the end-user and answer any
questions they may have on the use of the curved
stair lift. Ensure that the owner is comfortable and
confident in the lift's use.
24SEP2021 | 630-00063-01 REV D
INSTALLATION
HELIX: Install Manual
17