Komatsu ecot3 WA430-6 Operation & Maintenance Manual page 170

OPERATION
ADJUST SEAT BELT
Always wear the seat belt.
Before fastening the seat belt, check that there is no abnormality in the belt-mounting bracket or mounting of the belt. If the belt
is worn or damaged, replace it.
Fasten the seat belt before starting operations.
Always wear the seat belt during operations.
Make sure that the left and right belts are not twisted when fastening the seat belt.
FASTENING AND REMOVING BELT
Fasten the belt so that it is tight without being too tight.
1. Sit on the seat, depress the brake pedal fully, and adjust the
seat so that your back is pressed against the backrest.
2. After adjusting the seat position, adjust tether belt (1). Tense
the tether belt and install it when there is no one sitting on the
seat.
3. Sit on the seat, hold buckle (2) and tongue (3) with your left and
right hands, insert tongue (3) into buckle (2), then pull the belt
to check that it is securely locked.
4. When removing the belt, press the red button in buckle (2) to free the belt.
Fasten the belt along your body without kinking it. Adjust the lengths of the belt on both the buckle and the
tongue sides so that the buckle is located at the front, mid-point of your body.
ADJUST BELT LENGTH
To make belt shorter: Pull the free end of the tether belt.
To make belt longer: Set the fixed end of the tether belt at 90
degrees to the holder, and pull.
WARNING
OPERATION
3 - 113