Husqvarna LT 5005 Workshop Manual page 44

6. Remove the piston bolt.
7. Remove the spring unit.
8. Install in the opposite sequence. Clean the surfaces
between the bellows, the bellows support and the
outer tube before you install the engine.
7.8.3 To disassemble and assemble the spring
assembly
WARNING: The tension in the springs, in the
assembled tube, must be released gradually.
44 - Repair and servicing
1. Remove the spring unit. Refer to
install the spring unit LT 5005, LT 6005, LT 6005 H
on page 41 and To remove and install spring unit
LT 8005 on page 43 .
2. Turn the rod piston head counterclockwise to
remove it.
3. Drain the oil from the rammer leg. Refer to
replace the oil in the rammer leg on page 48 .
4. Remove the rammer shoe. Refer to
rammer shoe on page 47 .
To remove and
To
To replace the
1726 - 001 -