Husqvarna LT 5005 Workshop Manual page 42

4. Lift the crankcase and push down the outer tube.
Make sure that there is a distance (A) between the
crankcase and outer tube.
A
5. To keep the distance between the crankcase and
the outer tube, put a spacer between the piston rod
and the outer tube. You can make a spacer of a
small piece of wood, 10-12 mm thick.
42 - Repair and servicing
6. Remove the piston bolt.
7. Remove the spring unit.
8. Install in the opposite sequence. Clean the surfaces
between the bellows, the bellows support and the
outer tube before you install the engine.
1726 - 001 -