Husqvarna LT 5005 Workshop Manual page 38

14. Remove the shaft with a press tool.
15. Remove the seal and the snap ring with snap ring
pliers.
16. Remove the bearing with a press tool.
38 - Repair and servicing
17. Remove the needle bearing with a bearing puller.
7.7.2 To assemble the crankcase
1. Clean the parts and surfaces of the crankcase.
2. Use a press tool to install the 2 needle bearings in
the cover.
Note: The top of the needle bearings (A) must align
with the edges (B) of the holes.
A
B
1726 - 001 -