Husqvarna LT 5005 Workshop Manual page 24

3. Clean the oil from the dipstick.
4. Put the dipstick fully into the oil tank.
5. Remove the dipstick.
6. Examine the oil level on the dipstick.
7. If the oil level is low, fill with engine oil and do a
check of the oil level again. Refer to
LT 5005, LT 6005, LT 6005 H on page 49 for the
correct type of oil.
7.4.2 To do a check of the engine oil level LT 8005
1. Put the product in an upright position.
2. Remove the oil tank cap and dipstick.
3. Clean the oil from the dipstick.
4. Put the dipstick fully into the oil tank.
5. Remove the dipstick.
6. Examine the oil level on the dipstick.
7. If the oil level is low, fill with engine oil and do a
check of the oil level again. Refer to
LT 8005 on page 50 for the correct type of oil.
7.4.3 To replace the engine oil LT 5005, LT 6005,
LT 6005 H
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING: Engine oil is very hot directly after
the engine stops. Let the engine become cool
before you drain the engine oil. If you spill
24 - Repair and servicing
1. Put a container below the drain plug for the engine
2. Remove the oil drain plug.
3. Tilt the product and let the oil run out into the
Technical data
4. Install the oil drain plug and tighten it.
5. Fill with new engine oil. Refer to
6. Do a check of the engine oil level.
7.4.4 To replace the engine oil LT 8005
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
Technical data
oil warm and easier to drain.
engine oil on your skin, clean with soap and
water.
oil.
container.
LT 5005, LT 6005, LT 6005 H on page 49 for the
correct type of oil.
WARNING: Engine oil is very hot directly after
the engine stops. Let the engine become cool
before you drain the engine oil. If you spill
Technical data
1726 - 001 -