General Information - Blaupunkt BC3010 Instruction Manual

BC3010/5010
plug out of the socket. Keep the connection cable away from
heat sources, oils, sharp edges or moving parts. Damaged or
entangled connection cables increase the risk of an electric
shock.
Before starting the work, check the power cord before starting
the work. Do not operate if the power cord or extension cord is
abraded, cut or otherwise damaged. If the power cord is
damaged during use, switch off the device and unplug it from
the socket.
If the power tool is used outdoors, the connection cables
should be extended with waterproof extension cords designed
to operate outdoors. Using such an extension cord reduces the
risk of an electric shock. The cross-section area of the extension
2
cord conductors should be at least 1.5 mm when the length of
the cable is less than 20 m, and if the length of the cable is
2
between 20 and 50 m, the minimum cross-section is 2.5 mm .
A residual current protection device (RCD) must be used as
protection against shock from the supply voltage. Using the
RCD reduces the risk of electric shock. The equipment should
be supplied through an RCD with a rated current not exceeding
30 mA.

General information

The device is intended for house gardening use only as
described and protected by these instructions for use
After switching off the trimmer, the string/blade rotates for
some time. Wait until
the motor and the string/blade completely stop before
restarting the device.
Do not turn the trimmer on or off at short intervals.
The operator of the trimmer should wear proper footwear with
non-slip soles and long trousers to protect the legs. Do not
work barefoot or in flip-flops, sandals.
Always use the trimmer holding it with both hands.
7