Replacing A Contivity 4600 Hard Disk Drive - Nortel Contivity 4600 Installing

52 Chapter 4 Changing the Hardware Configurations

Replacing a Contivity 4600 hard disk drive

Figure 15
switch.
To replace a hard disk drive, you must do the following:
Software
First save any data that has not yet been saved to the hard disk from the disk
cache:
1
Use your Web browser to navigate to the switch, and go to the Admin!File
System display.
2
Click the button "Prepare selected device for removal."
Hardware
Next, remove the switch's front bezel as shown in
steps:
1
Insert and turn the hard disk drive key to the right. The LED becomes a "U"
for unlocked.
2
Pull the handle to remove the hard disk drive, as shown in
311641-A Rev 00
shows you how to replace Contivity 4600 hard disk drives for the
Caution: Hard disks are not hot-swappable.
Note: Turning the key shuts off the power to the hard disk drive.
Figure 9, and then follow these
Figure 15.