Flex FX3411 Operator's Manual page 13

SPEED CONTROL PANEL (FIG. 7)
The speed-selection button and the TURBO
function button of this tool enables the speed
to be adjusted according to the material being
sanded.
The speed levels are numbered "1" to "3",
with position "1" being the lowest speed and
position "3" being the highest speed. The
indicator lights show the current speed.
a. Use the speed-selection button to increase
or decrease the speed. Each press changes
the speed by one level.
b. Press the TURBO button at any speed level
to switch the tool to turbo mode. Press this
button again to return to the previous speed
level.
If the tool is OFF:
a. Press the speed-selection or the Turbo
button to "wake up" the control panel and the
indicator lights will indicate the current speed
level.
b. Change the speed level by pressing the
speed-selection button.
c. After approximately 15 seconds of inactivity
the indicator lights on the control panel will
turn off. The memory function will remember
and revert to the last active speed level the
next time when the speed-selection button
or the Turbo button is pressed or the tool is
turned on.
If the tool is already ON:
a. Change the speed level by pressing the
speed-selection button. You will feel and
hear the speed change and the indicator
lights will indicate the current speed level.
b. After you turn the tool off, the memory
function will remember and revert to the last
active speed level the next time the tool is
turned on.
Fig. 7
Speed-selection Button
Indicator Lights
-13-
T
Turbo Button