Nokia EM5400 Installation Manual page 40

3
Performing the Initial Configuration
4. Check the power LED (the Nokia logo) on the front panel of the appliance
40 Nokia EM5400 IP Security Platform (IP260 and IP265 Appliances) Installation Guide
EM5400 IP Security Platform includes IP260, IP265, 50i, 50s Appliances
Caution
To reduce stress on the power supply, when you turn the appliance
on, wait at least ten seconds before you turn it off. Likewise, when
you turn the power supply off, wait at least ten seconds before you
turn it back on.
Note
Because the flash-memory PC card is hot replaceable for the
EM5400, you do not need to install a flash-memory PC card to boot
from before you turn on the appliance.
Note
The EM5400 appliance power supply automatically detects the input
voltage (115 VAC or 220 VAC [100 to 127 and 200 to 240]) and
configures itself appropriately.
to ensure that the power supply is operating correctly.
If the fans are not running, or if the power LED is not illuminated, make
sure that:
The power cord is properly connected.
The power supply switch is on.
Power is turned on to the power strip or wall receptacle into which you
plugged the appliance.
If the fans are still not running, or if the power LED does not illuminate,
contact your Nokia service provider as listed in
Information" on page 3 for technical support.
"Nokia Contact