Section 6 Transportation; General Transportation - Will Burt Hurry-Up Mast 3.5-7 Operator's Manual

Section 6
Before transporting the mast system, the mast system needs to be secured. The exact
procedures for transportation will vary based on the mast system configuration. The process
described in this manual represents a possible method of transporting the mast. Depending on
the environment and equipment available, other methods may work better. Use the best and
safest method for your circumstances.

6.1 General Transportation

To prepare the mast system for transportation:
1. Ensure the mast is fully nested (Section 5.3). Do not transport the mast system with the
mast and payload extended. Always visually confirm the mast is fully retracted before
moving the mast.
2. If possible, remove and secure the payload.
3. If necessary, remove and secure the optional antenna stub.
4. If using the Drive-On Stand:
a. Remove mast from the ground plate assembly.
b. Carefully drive the vehicle off of the ground plate.
c. Secure Drive-On Stand for transport.
d. Secure mast for transport.
5. If using the hitch mount:
a. Remove the mast from the hitch mount.
b. If applicable, remove the Anti-Rattle Hitch Tightener from the hitch mount.
c. Remove the hitch mount from the vehicle.
d. Secure hitch mount for transport.
e. Secure mast for transport.
6. If necessary, secure any additional components in the mast system.
Note: The operator should always visually confirm the mast is entirely retracted before
moving the vehicle.
TP-5928001-C
February 2023
Transportation
H -U ® M O
URRY P AST PERATOR
'
M
S ANUAL
6-1