Drive-On Stand Installation (Optional); Figure 4-2 Mast Mounted With Drive-On Stand - Will Burt Hurry-Up Mast 3.5-7 Operator's Manual

H -U ® M O
URRY P AST PERATOR

4.6 Drive-On Stand Installation (Optional)

Physically attach the system as follows:
1. Position the ground plate approximately 2 feet in front of or behind a non-drive wheel,
preferably on the driver's side of the vehicle.
Note: The mast should not be inserted in the ground plate.
2. Carefully ease the vehicle onto the ground plate. If possible, observe from the driver's
side window that the vertical tube does not contact the vehicle as the tire rolls onto the
ground plate. Stop the vehicle when the tire is centered on the plate.
3. Stop the engine. Place the transmission in park and engage the parking brake.
4. The mast can now be lowered into the vertical tube on the ground plate assembly.
Rotate the mast so that the slot in the bottom of the mast drops over the key in the
bottom of the vertical tube.
5. Be sure to allow adequate clearance between the mast and the vehicle to allow for wind
deflection.
6. If using the optional antenna stub, see Section 4.8 for installation.
4-4
'
M
S ANUAL

Figure 4-2 Mast Mounted with Drive-On Stand

TP-5928001-C
February 2023