Table of Contents
Advertisement
4.7 Hitch Mount Installation (Optional)
Physically attach the system as follows:
1. Securely attach the hitch mount to the back of the vehicle. Make sure it is level.
7. If applicable, attach the Anti-Rattle Hitch Tightener to the hitch mount.
8. The mast can now be lowered into the vertical tube on the ground plate assembly.
Rotate the mast so that the slot in the bottom of the mast drops over the key in the
bottom of the vertical tube.
9. Be sure to allow adequate clearance between the mast and the vehicle to allow for wind
deflection.
10. If using the optional antenna stub, see Section 4.8 for installation.
4.8 Antenna Stub Installation (Optional)
To install the antenna stub:
1. Remove the locking pin from the antenna stub.
2. Insert antenna stub into top tube.
3. Line up the antenna stub and top tube holes.
4. Insert the locking pin through the lined-up holes to lock the antenna stub onto the mast.
Note: Twenty (20) pounds is the maximum top load capacity.
TP-5928001-C
February 2023
Figure 4-3 Secure Hitch Mount to Vehicle
H
-U
® M
O
URRY
P
AST
PERATOR
'
M
S
ANUAL
4-5
Advertisement
Table of Contents
