Printing Process - Cembre MG4 Operation And Maintenance Manual

5 Printing
18
Caution!
X Keep your hands away from the carriage area during printing.
X The printer will not start if the guard (3) is not correctly positioned.
i
Note!
To get the best printing results, we recommend following these rules:
• Only use genuine CEMBRE consumables (sheets, print ribbons, etc.).
• Handle the sheets carefully once out of the package and avoid touching the print area with your fingers.
• Before printing, always check that the sheets are free of dirt or residue. If necessary, clean the printing
surface with a soft cloth.
• Keep the sheets to be printed inside their packaging in a dry and clean place.
• When printing partially used sheets, make sure that there are no protruding burrs along the length of the
sheets along the punching edges or upward facing plates that could damage the print head.
• When printing partially used sheets, make sure that you are using a print file that has been suitably
modified for the number of sheets actually present on the sheet; executing a complete print with a partially
used sheet could irreparably damage the print head.
5.1

Printing process

Manually load a sheet onto the interface template in order to block its movement; the striker feet under the sheet
should match the holes in the template and the side stems should be facing the inside of the printer (Fig. 10).
After processing the print job using GENIUSPRO software, start printing.
The printing procedure includes the following phases:
1. The mobile carriage (1) retracts inside the printer.
2. The sheet is printed, then the carriage protrudes (1).
3. Manually remove the printed sheet from the template (Fig. 11).
Then manually detach the markers or tags from the sheet.
side stems
steli
Fig. 10
Fig. 11
striker
piedini
di riscontro
feet