BABYTREND Sit N' Stand Double 2.0 Instruction Manual page 7

Child Tray
4
WARNING:
device: always secure your child with the seat belt. DO
NOT lift the stroller by the child's tray. Use care when
child is in the stroller and securing the front tray. Do not
place hot liquids or more than 3 lbs (1.36 kg) in the child
tray. Serious burns or unstable conditions could result.
To attach child tray:
Push tray downward and onto each
side of the front armrests until
both sides snap into place (Fig. 4a).
Check that the tray is secured by
slightly pulling it upwards.
To access child seat:
Pull one release lever (Fig. 4b) on
the underside of the child tray and
lift upward. Either side can rotate
up to access the seat (Fig. 4c).
To remove the child tray:
Pull both release levers located on
the underside of each side of the
tray and lift upward (Fig. 4d).
NOTE: Repeat the above steps for
the rear child tray.
Fig. 4c
9
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
The child's tray is not a restraint
Fig. 4a
Release Lever
Fig. 4b
Release Lever
Fig. 4d
Moblie Phone Positioning Parent Tray
5
WARNING:
more than 3 lbs (1.36 kg) in the parent tray. Serious
burns or unstable conditions can result.
WARNING:
folding stroller to prevent damage. Make sure all
accessories, mobile phones, diaper bags or purses
are removed before folding. Failure to remove items
in, or on the stroller may result in damage to the
stroller or the item (s) if not removed. Baby Trend ® will
not be liable or warrant any damage.
To Insert The Parent Tray:
To attach the parent tray insert the
hole on the parent tray into the pin
on the handle. Align the opposite side
of the tray and press down until you
hear a "click". Pull up on the tray to
verify proper installation. Please be
careful not to pinch your fingers when
installing the parent tray (Fig. 5a).
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Do not place hot liquids or
Care must be taken when
"Click"
"Clic"
Fig. 5a
10