Display Of Results; Measurement Errors; Entering The Patient Identification - Henry Schein Urispec Plus User Manual

User manual Urispec
5.3. Display of Results
The sequence number (Seq.No.) as well as the patient identification (ID) will be
displayed with the results.
Positive findings are clearly marked by an asterisk (*) on the printout and on the
display. Additionally, it is possible to enable an acoustic signal on positive find-
ings.
The printout is light-sensitive and may turn yellow when exposed to light during
storage. For archiving purposes the printouts should be kept in a dark place
(patient file) or as a photocopy.
The result displayed may be printed again by pressing
will lead back to the start screen.
5.4. Measurement Errors
If the display shows "Measuring Error ..." instead of a result please read the
instructions (see 15. Error Messages and Fault Clearance, page 39).
Repeat the measurement. In case of permanent errors please contact HENRY
SCHEIN service.
5.5. Entering the Patient Identification
The patient identification needs to be entered before starting the analysis. This
can be done as follows:
a) Directly on the equipment: Pressing
phanumeric keypad. Enter the ID using the keys. To enter characters (i.e.
"Miller") press
ABC
same field within 0.5 seconds switches through the characters displayed on
the key. Wrong entries may be erased by pressing
20
Plus
®
RESULT
Seq.No: 0001
ID: 1234567890
2006.02.17 9:47
*BLD 10 ERY/uL
UBG NORM
BIL NEG
PRO NEG
NIT NEG
KET NEG
*GLU 50 mg/dL
pH 5.0
SG 1.005
LEU NEG
Display 4: Result
to change the character entry. Repeated pressing on the
Manual Urispec
in the start menu brings up an al-
ID:
.
Plus V2.01 HS USA / 04-19
®
. The return panel