DR Pro 475 Safety & Operating Instructions Manual page 14

Yellow/Brown
Wires
Figure 15
Ground Wire
Figure 16
Tongue
Assembly
Cable Ties
Light Plug
Figure 17
DR ®
14 SELF-FEEDING WOOD CHIPPER
10. There may be as much as 16 feet of extra wire at each Tail Light location
Tail Light
11. Strip (remove) 1/2" of insulation from the ends of the Yellow/Brown wires
12. At the left side of the Chipper, insert the Yellow Wire into the top left hole in
Note: The wires are retained in the light socket holes by spring-loaded connectors.
13. At the right side of the Chipper, insert the Green Wire into the top left hole
Cable Tie
14. Secure the Wires to the Light Brackets with Cable Ties.
15. Reinstall the Tow Hitch and secure with the Bolts and Locknuts, but leave
16. Remove the Ring Terminal from the end of the White Ground Wire with
17. Remove 1" of insulation from the end of the Ground Wire with the Wire
18. Wrap the White (Ground) Wire around the front Tow Hitch Bolt and tighten
19. Secure the Wires to the Tongue Assembly between the two large Bolts to
Hitch Bolt
20. Secure the colored and white wires together with some Cable Ties.
Cable Tie
(Figure 15). Cut the excess Wire, leaving enough to insert into the back of
each Light after Wires are stripped in the next step.
and Green/Brown wires with Wire Strippers and twist the individual wire
ends to aid in installation.
the back of the light socket. Insert the Brown Wire into the top right hole.
in the back of the light socket. Insert the Brown Wire into the top right
hole.
the front bolt loose for the following steps (Figure 10).
Wire Cutters (Figure 16).
Strippers.
the Bolt.
ensure they will not get caught between the Tongue and Ball of the Tow
vehicle (Figure 17).