Figure 135: Installing A Routing Engine In An Mx240 Router - Juniper MX480 Hardware Manual

3d universal edge router

Hide thumbs Also See for MX480:

Table of Contents

Press both of the ejector handles inward to seat the Routing Engine. Tighten the

captive screws on the top and bottom of the Routing Engine.

Connect the management device cables to the Routing Engine. After the Routing

Engine is installed, the

Replace the former master Routing Engine, RE0, with the Routing Engine RE-S-X6-64G.

The Routing Engine RE-S-X6-64G is supported only on the SCBE2.

RE-S-X6-64G is not compatible with the SCB or the SCBE.

The Routing Engine might require several minutes to boot. After the Routing Engine boots,

verify that it is installed correctly by checking the

interface. If the router is operational and the Routing Engine is functioning properly, the

LED on the Routing Engine lights steadily. If the red

Engine lights steadily instead, remove and install the Routing Engine again. If the red

LED still lights steadily, the Routing Engine is not functioning properly. Contact your

customer support representative.

Figure 135: Installing a Routing Engine in an MX240 Router

Chapter 24: Replacing Host Subsystem Components

LED starts blinking green slowly.

LEDs on the craft

LED on the Routing