Parameter Settings - ABB UniSec Digital Operation And Maintenance Manual

Hide thumbs Also See for UniSec Digital:
Table of Contents

Advertisement

D I S T R I B U T I O N S O LU T I O N S

Parameter Settings

Click "Set" on the upper right of the interface to set
the related parameters e.g.,circuit breaker
parameters, switchgear parameters and language
information.
Temperature measurement parameter setting
Click "Temperature Measurement Parameters" to
enter the temperature setting interface. This option
is used to set the frequency band (from 1 to 60), the
reverse phase sequence of the switchgear (A-B-C or
C-B-A) and the over-temperature alarm threshold
(from 20°C to 115°C). Please click "Save" and
"Update" in sequence after setting.
Temperature
measurement parameter
setting
The "Advanced Settings" on the upper
right of the interface is to change the ID
of the temperature measurement
module, the settingis generally operated
by ABB field service engineers. If change
required, please contact ABB.
The frequency bandhas been set up in
manufacture. It is not recommended to
modify it without authorization,
otherwise it may lead to the failure of
communication.
Switchgear parameter and APP language settings
The information of the switchgear can be viewed by
clicking "Switchgear Settings". Name, model,
factory number and Modbus address can be set
through "Edit" on the upper right. And please do not
set same Modbus addresses fortwo different
switchgears. After setting, click "Save" and "Update"
to complete the setting.
Switchgear parameter setting
17

Advertisement

Table of Contents
loading

Table of Contents