Table of Contents
Advertisement
G O B O
INSTALLATION
Remove the screw from the gobo holder, and open up the two halves of the gobo holder (Fig. 1).
Please note that the half of the gobo holder with the raised surface is the front, while the half
with the flat surface and the handle is the back. Insert the gobo, making sure that the front face of
the gobo is facing the front of the gobo holder, then re-insert and tighten the screw to close the gobo
holder. Next, locate the plate on the barrel near the safety cable loop that is held in place with two
knobs. Loosen that knobs and slide the plate forward to expose the gobo slot (Fig. 2). Insert the gobo
holder into the gobo slot, making sure that the front of the gobo holder is facing towards the front of
the barrel. Slide the plate back into place and tighten the knobs to secure the gobo holder in place.
1
2
16
Advertisement
Table of Contents
