Oki B8300 User Manual page 87

10. Turn roller rotating knob in the direction
of the arrow.
11. Remove any misfed paper from the saddle
stitch tray. Be careful not to tear the
misfed paper during removal.
Troubleshooting (saddle stitch finisher problems)
Check the list below before calling for service.
Problem Check
Stapling position is not Stapling position not set properly?
correct (including
saddle stitch).
The saddle stitch Are any saddle stitch finisher covers open?
finisher does not
Message indicating need to remove paper from the
operate.
stapler compiler displayed?
Stapling cannot be Message requesting check for the staple unit
performed (including displayed?
saddle stitch).
Message requesting adding staples displayed?
Different size paper included?
Stapled sets are not Paper heavily curled?
stacked correctly or
some sheets in a set are
not stapled.
Cannot be punched.* Message requesting check for punch module
displayed?
* When a hole punch module is installed
12. Close the saddle stitch section cover.
13. Close the front cover.
14. Push the saddle stitch finisher back
Solution or cause
Check the stapling position setting.
Close all covers.
Remove all remaining paper from the stapler
compiler.
Remove jammed staples.
Replace the staple cartridge
Check that a staple cartridge has been installed.
Stapling cannot be performed on to different size
paper.
Paper may be curled heavily depending on the paper
type and quality. Remove paper from the paper tray
or the bypass tray, turn it upside down, and load it
again.
Dispose of punch scraps.
Saddle stitch finisher — 86
against the printer.