Table of Contents
Advertisement
D I ST RI B U T I O N SO LU TI O N S
—
1. Packing and transport
Each fixed part is packed according to the shipping
and storage requirements of the customer.
Each fixed part is protected by a plastic cover to
prevent any water entering during the loading and
unloading stages and to keep it free of dust during
storage.
The fixed parts must be placed on the transport
vehicle platform back-to-back and transversely,
placing materials between them suitable for
absorbing any compression and to avoid any direct
contact between the surfaces of the various
groups.
Special longitudinal members must be placed on the
platform to space each fixed part and prevent it
moving either longitudinally or transversely.
The fixed parts must be anchored to the structure of
Follow the symbols and instructions shown
on the packing carefully.
the vehicle with ropes, so that there is not
deformation and to prevent tilting on bends or in the
case of sudden stops.
The transport vehicle must also have a tarpaulin
cover over the whole load.
The resting points of the lifting means must have a
specific capacity to ensure proper weight
distribution.
To unload the fixed parts, there must be an area at
the same level and with dimensions not less than
3 x 2 m in front of the access to the warehouse or
switchboard room.
See paragraph 4 for handling.
Small differences in level can be compensated with
temporary structures made using wooden boards.
Unloading must be carried out with the utmost care
using suitable lifting equipment for the weight of
each group.
Special attention must be paid and the specific risks
analysed for working in areas with live overhead lines.
3
Advertisement
Table of Contents
