Adding A Function Code; Defining Sources; Select Or Edit Source; Cleaning Up An Ir Library - Nuvo Concerto NV-I8DMS User Manual

Screen 2.5
When a new code is added, while it is still highlighted,
click on the test button. This will open the IR Library
Test window. Make sure that the IR Learning Interface
box's IR emitter is either facing the IR receiver window
of the source equipment or an IR emitter is plugged
into the IR emitter output and affixed to the IR receiv-
er window of the source equipment. Clicking on the
test button will cause the IR Learning interface to emit
the code. The source equipment should respond appro-
priately to the command if it has been stored correctly.
A test result box will open where you can record yes or
no to the test. Three successful test results are
required before the "Passed" count turns green.
Clicking the "OK" button will save the results in the IR
Library. The "Tested" column for that command will
show the number of successful tests performed.
Although not required, testing each code is highly rec-
ommended.
2.6

Adding a Function Code

If a required IR code is not in the list of codes, it is pos-
sible to add a code to the list by clicking the "Create
New" button. The pull-down menu contains a list of all
standard IR codes. A name not found in the list can be
typed in, but it is recommended that you use the
names provided in the list. This conserves memory in
the Concerto. Clicking on the "OK" button proceeds
directly to the IR recording process.
2.7

Cleaning Up an IR Library

Unused IR codes can be deleted from the list by high-
lighting the code and either clicking the
"Delete" button or right-clicking and selecting "Delete."
When you are finished editing the library, select
"Done."
Screen 2.7
3. 0

Defining Sources

The "Sources" tab allows you to define the source com-
ponent attached to each of the six source inputs. All
six sources are not needed, but at least one source
must be defined.
Screen 3.0
3.1

Select or Edit Source

Double-clicking on a blank source will open the "Select
Source" window. This window assigns the appropriate
source number input. The "Display Name" is the text
that will be read on the Display Pad when that source
is selected in any zone. The display name can contain
only capital letters, numbers, and some punctuation. If
an invalid key is typed, it will be ignored.
The "Make" field defines the manufacturer of the equip-
ment. A drop-down menu allows you to choose a source
from the IR Library. The "Model" field provides a drop-
down menu that allows you to choose the specific piece of
source equipment from the selected manufacturer.
17