Table of Contents
Advertisement
IV.
Installing the NV-I8EZP EZ Port
(fig.3)
The EZ Port is a multi-connection hub designed to
accept all the Cat-5 wires from the keypads in the sys-
tem. The location of the EZ Port should be determined
by the location of the Concerto amplifier. It is best to
place in a wall behind the amplifier that would be easi-
ly accessible if necessary.
The EZ Port fits easily in any dual-gang-size, low-volt-
age ring with an open back. These are often referred to
as "mud rings." Simply plug the terminated Cat-5 wires
into any of the 20 available jacks on the back of the EZ
Port. The order in which the individual Cat-5 wires are
plugged in is not important, although it is strongly rec-
ommended that you label the Cat-5 with the appropri-
ate zone number for future reference.
Once you have plugged the Cat-5 wires into the EZ
Port, screw the EZ port into its construction bracket
using the supplied mounting screws.
Fig. 3
V. Connecting the EZ Port to the
Concerto Amplifier (fig. 4)
When the EZ Port is installed in the wall, the only part
visible should be the faceplate and four RJ45 jacks. The
supplied pre-terminated network cable should then be
plugged into the RJ-45 connection labeled "Connect to
the NV-I8M ONLY". Any Cat-5 cable terminated using
568A or 568B network wiring will suffice should you
need a longer connection.
Fig. 4
EZ Port (front)
Peripheral
Device 1
Peripheral
Device 2
Concerto EZ Port
NV-I8DEZP
Peripheral
Device 3
Connect to
NV-I8DM
ONLY
12
Concerto Network
Connection
PROGRAM
SYS ON
CONNECT TO
CONNECT TO
NV-I8DEZP
NV-I8DX
USE NV-NC1
USE NV-SLC1
CABLE
CABLE
EXT. MUTE
SYSTEM
NETWORK
DIGITAL LINK
Network Cable
Hide quick links:
Advertisement
Table of Contents
