Capturing Ir Codes Using The Ir Learning Station Interface; Using The Nv-I8Dslv Secondary Keypad - Nuvo Concerto NV-I8DMS User Manual

Capturing IR codes using the IR Learning
Station Interface (fig. 10)
The Concerto Configurator software is designed to
store IR codes for audio equipment in an IR Library.
When the codes are learned for a given piece for equip-
ment, they are held in the library under that equip-
ment's manufacturer name and model number. Once
learned, any of the equipment in the library can be
imported into a new Configuration.
To learn new equipment codes, the Learning Station
Interface box must be connected to your computer at
the RS232 port. Connect the male end of the RS232
cable to the back of the Interface box into the "CON-
NECT TO PC" input. At this point, it is not necessary to
have the Interface box connected to the Concerto
amplifier.
When setting up a new source, each type of equipment
has a pre-selected set of functions. By double-clicking
on a function or clicking on the "Record" button in the
software, you will open the record window. You will see
Using the NV-I8DSLV Secondary Keypad (fig. 11)
The NV-I8DSLV is a simple, single-gang keypad
designed to provide simple control in a secondary area
within a zone (e.g., a dressing room off of the master
Front
VOLUME
SOURCE
PWR MUTE
Fig. 11
Back
Concerto DisplayPad
Model NV-I8DSKP
NuVo Technologies LLC Cincinnati, Ohio USA
www.nuvotechnologies.com
NuVo Concerto System
WARNING:
Connect only to
NuVo Concerto System
AVIS:
Utiliser uniquesment avec
ETL CE
c
us
FCC S
Connect to NV-I8DDSP DisplayPad
The NV-I8DSKP daisy-chains between
the "Slave RJ45" input on the back of
the Display Pad with a single Cat-5 run.
the "READY" LED light on the interface box. Aim the
source's remote control at the "IR SENSOR" on the
Interface and press the desired function button on the
remote. The IR learning window in the Configurator
software will indicate that the code has been success-
fully learned. Note that the remote control should be
held 8 to 10 inches from the Interface when learning.
Concerto Learning Station
Model NV-I8DLS
PASSTHRU READY IR SENSOR
Fig. 10
bedroom). The Secondary Keypad must operate from
the "Slave" RJ-45 input on back of the Zone's Display
Pad. It is connected to the system by daisy-chaining
the secondary keypad to the Display Pad.
NuVo Technologies LLC
NuVo Concerto System
26
POWER
TEST ACTIVE
Hold the source
remote control 8-10
inches from the
Learning Station
Interface.
Concerto DisplayPad
Model NV-I8DDSP
Cincinnati, Ohio USA Made in China
www.nuvotechnologies.com
WARNING AVIS
Connect only to Utiliser uniquement avec
NuVo Concerto System
3033118
ISP NV-LSI24
Network Slave