Setup And Installation; Network Requirements; Installing The Nv-P3100-Xx, Nv-P3500-Xx, And Nv-P4300-Xx Players; Connecting Speakers To The Nv-P3100-Xx, Nv-P3500-Xx, And Nv-P4300-Xx Players - Nuvo NV-P3100 series Product Manual

SETUP AND INSTALLATION

NETWORK REQUIREMENTS

A live Internet connection is necessary for initial setup of your Nuvo Player Portfolio System. For wired Ethernet
connectivity, a minimum 100 MB wired network is necessary for proper communication. Wireless-compatible devices
use dual band 802.11n wireless communication. To ensure that all components are compatible and communicating
correctly, it is strongly suggested that network routers using the older 802.11g protocol be upgraded to support
Multicast and UPnP and be Wi-Fi
When using an Ethernet connection to the system router, or for initial setup, make a connection from your home
network to one Ethernet port (
INSTALLING THE NV-P3100-XX, NV-P3500-XX, AND NV-P4300-XX PLAYERS
Connect your rack-mount player to your network by inserting one end of a standard Ethernet cable into an Ethernet
port on the player and use the other end to connect directly to your home network. Some players have two Ethernet
ports. You can choose either of the two Ethernet ports for connection.
IMPORTANT: The NV-P3100-XX, NV-P3500-XX and NV-P4300-XX are not wireless devices and do not use Wi-Fi for communication.
CONNECTING SPEAKERS TO THE NV-P3100-XX, NV-P3500-XX, AND NV-P4300-XX PLAYERS
NOTE: Speakers can be bookshelf, floor-standing, or installed in the wall or ceiling. 16-gauge speaker wire is recommended. Up to 12-gauge speaker wire can be used, if desired.
The rack-mount players have three separate zone "euro" style speaker connectors that use a modular plug. To
connect the speakers, perform the following steps:
Strip approximately 1/4 inch of insulation from the inner conductor wire.
1.
Terminate the speaker wire into the modular plug.
2.
Insert the plug into the appropriate zone output on the back panel (See Figure 1).
3.
IMPORTANT: Be careful not to let the exposed speaker wires touch. This will short the connection and could damage the amplifier.
Player Portfolio Audio System | Product Manual
Certified before you proceed with the setup.
®
) on the device, using a standard Ethernet cable.
Figure 1
8