Service And Adjustments; Service Position; Hydraulic Fluid - Gravely Pro-Turn 100 Operator's Manual

Gravely dealers will provide any service which
may be required to keep your unit operating at
peak efficiency. Should engine service be
required, it can be obtained from a Gravely
dealer or the engine manufacturer's
authorized service center.
WARNING: AVOID INJURY. Read
and understand entire Safety section
before proceeding.
CAUTION: HOT SURFACES may
result in injury. DO NOT touch engine
or drive parts which are hot from
operation. Allow parts to cool before
servicing.

SERVICE POSITION

(Figure 7)
CAUTION: Be sure footing is secure
to accomodate weight shift of seat
when rotating it into service position.
1. Move steering levers outward.
2. Pull seat release lever.
3. Tip seat forward.
NOTE: Seat release lever is spring activated.
When returning seat to upright position seat
will automatically lock in place.
Figure 7

SERVICE AND ADJUSTMENTS

HYDRAULIC FLUID

WARNING: HYDRAULIC FLUID can
result in severe burns. Fluid in
hydraulic system can penetrate skin
and result in serious injury or death.
Be sure to stop the engine before
doing any work on hydraulic parts.
Keep body and hands away from pin
holes or nozzles which expel
hydraulic fluid when under pressure.
Use paper or cardboard, not hands,
to search for leaks.
Ensure all hydraulic fluid connections
are tight and all hydraulic hoses and
lines are in good condition before
applying pressure to system.
FOREIGN FLUID INJECTED INTO
BODY can result in gangrene. Fluid
must be surgically removed within a
few hours by a doctor familiar with
this form of injury.
Check Hydraulic Fluid Level
(Figure 8)
Check the system with the unit cold and
parked on a flat, level surface.
Then run the unit for about one minute and
recheck the levels.
To Add Hydraulic Fluid
(Figure 8)
1. Remove the cap from the expansion
tank.
2. Fill the expansion tank with 15W-50
synthetic motor oil (Gravely p/n
00057100) or equivalent until oil level
reaches the cold fill line on the tank.
3. Reinstall the expansion tank cap.
EN - 23