Page 2
This lift is only suitable for lowering and lifting screens with a max. allowed load in strict vertical direction. Deze lift is alleen geschit foor het op en neer bewegen van een beeldscherm in strikt verticale beweging. Mount lift to a wall using indicated mounting brackets. Make sure the lift is installed strict verttical.
Page 3
See attached manual of the PCB for correct connection and control of the lift. Zie de bijgevoegde handleiding van de besturing voor het juist aansluiten en bedienen van de lift.
Page 4
Place mounting cams (4X) into back of flat panel as shown. Max allowed load 100kg. (Refer to Flat panel manual to ensure correct bolt length is used). Plaats de montage nokken (4X) in de achterkant van het scherm zoals weergegeven. Maximale belasting 100kg. (Zie beeldscherm handleiding voor correcte bout lengte)
Page 5
Place flat panel with installed mounting cams in slots as shown. (VESA 600x400) Plaats het scherm met montagenokken in de sleutel gaten zoals weergegeven. (VESA 600x400).
Page 6
Place or remove top cover. Top cover is secured with 4x countersunk bolts as shown. Always use lift with cover!! Attention, under the cover the motor is installed, beware of fingers, clothing and long hair. Monteren of verwijderen van de topcover. De topcover is bevestigd met 4x verzonken bout zoals weergegeven.
Page 7
Audipack reserves the right to make changes in specifications and other information contained in this document without prior written notice. The information provided herein is subject to change without notice. In no event shall Audipack be liable for any incidental, special, indirect, or consequential damages whatsoever, including but not limited to lost profits, arising out of or related to this manual or the information contained herein, even if Audipack has been advised of, known, or should have known, the possibility of such damages.
Need help?
Do you have a question about the FWS-7075V and is the answer not in the manual?
Questions and answers