Wiring the Carrier® Connect™ Wi-Fi Thermostat
Air Handler or DX Coil/Heat Pump split system
To wire and mount the thermostat
Turn off 24 Vac power at the equipment circuit breaker or the system switch.
1
Place the thermostat base against your wall to mark drill holes.
2
Drill the anchor holes or use existing holes to mount the wallplate.
3
Drywall — Drill 3/16 in. hole for the anchor.
○
Plaster — Drill 7/32 in. hole for the anchor.
○
Pull wires through opening in base.
4
Attach the base to the wall with the provided screws.
5
33CONNECTSTAT43
Installation Guide
4
©2022 Carrier.
All rights reserved.