Table of Contents
Advertisement
Swipe or click to navigate to the SETTINGS screen.
3
NOTES
Navigate by clicking or pressing the buttons such as SETPOINTS, FAN, PROGRAM, etc...
○
Grayed out function buttons indicate that feature is not being used on the thermostat.
○
Screens
SETPOINTS
FAN
NOTE The following selections are not available if the thermostat has been configured for non-programmable
operation.
HUMIDITY
PROGRAM
33CONNECTSTAT43
Installation Guide
Use to...
Adjust the occupied and unoccupied setpoints by selecting each temperature.
View and modify fan settings.
•
The default setting for fan operation is AUTO for both Occupied and Unoccupied periods.
When operating in AUTO MODE, the fan only runs when there is an active heating or
cooling demand.
•
When you select ON, the fan runs continuously, except during the Blower On Delay when
a heat cycle is starting. There is a 30-second minimum on/off timer when changing the
FAN MODE.
Adjust the thermostat's humidify and dehumidify setpoints.
You can:
•
Set Occupied and Unoccupied start times, depending on the configured number of
periods and the user's security level.
•
Select the time at the bottom of the screen to adjust the start or stop time of each
period in 15 minute increments.
•
Select Copy to apply that schedule to other days of the week.
•
Adjust the setpoints for each period.
Registering and setting up a mobile device for enhanced access
11
©2022 Carrier.
All rights reserved.
Advertisement
Table of Contents
