CONTENTS
GENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-7
Set Clock. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Factory Defaults . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Calibrate Sensor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Final Checklist . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-9
Auto-Changeover . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Clock Backup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Fan Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Emergency Heat . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Electric Heat . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Holiday Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Keypad Lock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
10-Watt Resistor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
IMPORTANT: Read entire instructions before starting
the installation.
SAFETY CONSIDERATIONS
Read and follow manufacturer instructions carefully. Fol-
low all local electrical codes during installation. All wiring
must conform to local and national electrical codes. Improper
wiring or installation may damage thermostat.
Recognize safety information. This is the safety alert sym-
bol
. When the safety alert symbol is present on equipment
or in the instruction manual, be alert to the potential for person-
al injury.
Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.
PC 111
Book 1
4
Tab
11a 13a
Commercial Programmable Thermostat
Installation, Start-Up and
Operating Instructions
Part Numbers 33CS250-FS
and 33CS220-FS
Page
Catalog No. 533-352
Printed in U.S.A.
Flush-Mounted FlatStat
Understand the signal words DANGER, WARNING, and
CAUTION. These words are used with the safety alert symbol.
DANGER identifies the most serious hazards which will result
in severe personal injury or death. WARNING signifies a haz-
ard which could result in personal injury or death. CAUTION
is used to identify unsafe practices which would result in minor
personal injury or property damage.
GENERAL
The commercial, 7-day, programmable thermostats are
wall-mounted, low-voltage thermostats which maintain room
temperature by controlling the operation of an HVAC (Heating,
Ventilation, and Air Conditioning) system. Separate heating
and cooling set points and auto-changeover capability allow 4
different programming time periods for energy savings.
All thermostats allow up to 4 time/temperature settings to
be programmed per 24-hour period. Each thermostat stores
programs for 7 independent days. Batteries are not required.
During power interruption the internal NEVER-LOST™
memory stores programmed schedules for an unlimited
amount of time while the clock continues to run for at least
48 hours.
The thermostat can be configured to accept several different
equipment configurations, including heat pump operation.
NOTE: The thermostat is not factory-configured for use in heat
pump applications. The advanced setup must be performed to
configure the thermostat for use with heat pump units.
→
NOTE: The 33CS250-FS thermostats have wiring connections
for a remote room sensor and dry contacts. The 33CS220-FS
thermostats do not have these connections.
PACKAGE CONTENTS
ITEM
Thermostat
Cutout Template
1-in. Screws (Junction Box Installation)
1
1
/
-in. Self-Tapping Screws
2
(Non-Junction Box Installation)
Plastic Tabs
Power Resistor (270 ohm, 10 Watt)
Form 33CS-35SI
Pg 1
Debonair®
33CS
QUANTITY
1
1
2
2
2
1
105
9-00
Replaces: New