Self test procedure for the VR-7024F
1. Remove the capsule from the bracket.
2. Move the switch to the test position and hold until the test
indicator lights.
Test sequence
1) The test indicator goes off briefly every time a signal
is transmitted.
2) If the RLS protocol is enabled, the blue RLS indicator
will light for approximately 1 second.
3) The strobe light will flash once if the self test is suc-
cessful. If the self test detects a fault in the EPIRB module, the test indicator
will start flashing at the end of the test.
*: For EPIRBs with RLS disabled, the RLS indicator will remain off.
**: See "Test failure indications" below.
Test failure indications
If one of the sequences in the extended or normal self test is unsuccessful, the
test indicator will flash a number of times according to the table below to indicate
the occurred failure. For details of each failure, see the Jotron's manual.
3. When the result of the test is not "OK", change the location and retry the self test.
If not resolved, contact your dealer.
2. MAINTENANCE
2-7