Chapter 3: Configuration; Nvg Configuration For Tps Remediation - Nortel 2070 Configuration

NVG configuration for TPS remediation

N TPS R
ORTEL EMEDIATION
C 3
HAPTER
C
ONFIGURATION
This chapter describes configuration of the Nortel TPS Remediation Module for
the Nortel VPN Gateway (NVG).
Configuration on the NVG is done through the command line interface (CLI)
allowing the interaction with the TPS remediation module to occur. TPS can be
configured to use either telnet or secure shell (SSH) to communicate with the
NVG.
If telnet is used as the communication protocol, run the following CLI commands
for NVG Configuration.
1. Enable the Telnet option in the NVG CLI (see
2. At the main command line prompt, enter the following command:
/cfg/sys/adm/telnet on
3. At the administrative applications prompt, enter the following command:
apply
The system responds with the message Changes applied successfully.
4. The control then returns to the administrative applications prompt.
If SSH is used as the communication protocol, run the following CLI commands
for NVG Configuration.
1. Enable the SSH option in the NVG CLI.
2. At the main command line prompt, enter the following command:
/cfg/sys/adm/ssh on
M NVG—I
ODULE FOR NSTALLATION AND
Figure
C
ONFIGURATION
3)
R 4.7.0.2 11
ELEASE PAGE