The settings of Port2: Protocol
4
macro Settings are listed as
shown on the right. (The figure
on the right shows the default
settings.)
As the set value for Port
5
settings, select User settings.
In the same way as in step 5, set
6
the parameters as follows.
・Serial communications mode: Protocol
macro
・Data length: 8 bits
・Stop bits: 1 bit
・Parity: None
・Baud rate: Default (9600bps)
・ Protocol Macro Transmission method:
Full-duplex
* For other parameters, leave
the default settings.
Click Transfer [PC to Unit].
7. Connection Procedure
31