Nortel SCS User Manual page 29

Installing the Slave System
After you install SCS on the Master System, you are ready to set up the Slave System. Power on the Slave System and perform the
following steps:
Note Before setting up a Slave System, make sure the Master System is running and available on the network.
1 Log on to the Slave System with the following credentials, and press Enter after each entry:
Username: root
Password: setup
After you log on, the setup wizard automatically starts.
2 On the dialog box that appears, press Enter to start SCS configuration.
3 Select HA System in the dialog box; use Tab or your mouse to navigate among options. When you highlight the HA System option,
press Enter.
4 Begin configuration of the Slave system by selecting Slave HA System in the dialog box; use Tab or your mouse to navigate among
options. When you highlight the Slave HA System option, press Enter.
2007 Nortel Software Communication System v1.0
HA System installation
Page 17