Supermicro X13SEW-TF User Manual page 90

Super X13SEW-TF/-F User's Manual
SATA SGPIO Mode
Use this feature to enable serial GPIO for the SATA controller to ensure which storage driver
can monitor and auxiliary service in a drive enclosure. This feature is only valid in AHCI/RAID
mode. When you select Enable, it supports multiple-activity LEDs to show the per drive status
information from the Front Panel. When you select Disabled, the SGPIO signals are off to
deliver the LED messages from the Front Panel. The options are Disabled and Enabled.
Note: The signals are not related to SATALED.
SATA Port 0–SATA Port 1
This feature displays the information detected on the installed SATA drive on the particular
SATA port.
Hot Plug
Select Enable to support Hot-plugging for the device installed on a selected SATA port.
This feature allows you to replace the device installed in the slot without shutting down the
system. The options are Disabled and Enabled.
Spin Up Device
Select Enable for Staggered Spin Up support. This feature allows the SATA devices you
specified to spin up one at a time at boot up in an effort to prevent all hard drive disks
from spinning up at the same time, causing a power surge. The options are Disabled and
Enabled.
SATA Device Type
Use this feature to specify if the device installed on the SATA port you specified should be
connected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive
and Solid State Drive.
90