Pentair EVERPURE QL3B 7FC5 Installation, Operation, Maintenance Manual

QL3B 7FC5, QL3B 4FC5, QL3B 2FC5, QL3B 2FC5-S
WATER FILTRATION SYSTEMS
INSTALLATION, OPERATION & MAINTENANCE GUIDE
INTRODUCTION
The new Pentair® Everpure® QL3B FC Series water filtration systems are designed to provide optimum water characteristics for its
specified applications. These systems can help reduce equipment maintenance, extend equipment life, and help improve the quality
and consistency of your products. Built with high quality materials, each system is quality inspected prior to shipment. Proper system
installation and routine filter changes will ensure years of trouble-free operation and performance.
NOTES
Do not discard. Give this guide to the owner/operator after installation.
• Installation must conform to all local plumbing codes and
regulations.
• Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system.
• Connect system to cold water supply only.
Water temperature must not exceed 100°F (38°C).
• Do not solder plumbing connections attached to the assembly.
High temperature will damage these components.
OPERATING SPECIFICATIONS
For use on cold water only.
Pressure Requirements:
Temperature:
Refer to this manual for general installation, operation, and maintenance requirements.
Performance Specifications
Part
Model Number gallons
QL3B 7FC5 EV925973 25,000
QL3B 4FC5 EV925972 15,000
QL3B 2FC5 EV925970 6,000
QL3B 2FC5-S* EV925971 6,000
*Denotes WaterMark
PENTAIR EVERPURE QL3B FC SERIES WATER FILTRATION SYSTEMS INSTALLATION, OPERATION & MAINTENANCE GUIDE FOODSERVICE.PENTAIR.COM
10 - 125 psi, non-shock
(0.7 - 8.6 bar), non-shock
35 -100°F (2 - 38°C)
Capacity Flow Rate
Scale
liters gpm lpm Inhibitor
94,635 2.5 9.46 No
56,781 2.5 9.46 No
22,713 1.5 5.68 No
22,713 1.5 5.68 Yes
• Do not mount the system behind equipment. The unit must be
easily accessible for filter replacement.
• Do not install system where it may interfere with moving
equipment, carts, mops or any other item that may cause
damage.
• Allow a minimum of 21/2" (6.35 cm) clearance under the filter to
facilitate cartridge change.
• Not for residential use. For foodservice applications only.
Reduces
Particulate Class III, Chlorine, Taste & Odor
Particulate Class III, Chlorine, Taste & Odor
Particulate Class III, Chlorine, Taste & Odor
Particulate Class III, Chlorine, Taste & Odor
AS/NZS 3497
WM-40206
Global-Mark.com.au
QL3B 7FC5, QL3B 4FC5, QL3B
2FC5, QL3B 2FC5-S models are
are Tested and Certified by NSF
International against NSF/ ANSI
Standard 42 for the reduction of:
STANDARD NO. 42 —
AESTHETIC EFFECTS
Bacteriostatic Effects
Chemical Reduction
Taste & Odor
Chlorine
Mechanical Filtration
Nominal Particulate Class III