CORDLESS ROTARY HAMMER DRILL COMPONENT LIST DUST PROTECTION CAP TOOL HOLDER LOCKING SLEEVE FUNCTION MODE SELECTION SWITCH ON/OFF SWITCH (WITH VARIABLE SPEED CONTROL) FORWARD AND REVERSE ROTATION CONTROL BATTERY PACK* BATTERY PACK RELEASE BUTTON* LED LIGHT *Not all the accessories illustrated or described are included in standard delivery.
CORDLESS ROTARY HAMMER DRILL ACCESSORIES conditions. Water entering a power tool will increase the risk of electric shock. SDS to 6.35mm Hex adaptor d) Do not abuse the cord. Never use the cord for Screwdriver bits (PH2*50mm,PZ1*50mm,PZ2*50mm, carrying, pulling or unplugging the power tool. Slotted*5.5mm*50mm) Keep cord away from heat, oil, sharp edges SDS drill bits (6mm,8mm)
Page 6
CORDLESS ROTARY HAMMER DRILL 4) Power tool use and care d) Under abusive conditions, liquid may be ejected a) Do not force the power tool. Use the correct power from the battery; avoid contact. If contact tool for your application. The correct power tool accidentally occurs, flush with water.
CORDLESS ROTARY HAMMER DRILL GENERAL SAFETY WARNINGS liquid to come into contact with the skin or eyes. If contact has been made, wash the affected WARNING! Read all safety warnings and all area with copious amounts of water and seek instructions.
Page 8
CORDLESS ROTARY HAMMER DRILL SYMBOLS from inflammable materials. Batteries can get hot during charging. Do not overcharge any batteries. Ensure that batteries and chargers are not left To reduce the risk of injury, user must read instruction manual unsupervised during charging. 15.
CHARGING YOUR BATTERY PACK (See Fig. B1 , B2 ,B3) battery pack (ABP118W2/ ABP218W4) illustrated or Do not use any charger other than that specifically described are not included in RD2990.9 delivery. provided for use with the equipment. If the battery pack is very hot you must remove your battery pack from the charger and allow time for the battery to cool down before recharging.
Page 10
5. FUNCTION MODE SELECTION (See FIG. E) battery pack (ABP118W2 / ABP218W4) illustrated or The operation of the gearbox for each application is set described are not included in RD2990.9 delivery. with the function mode selection switch(3). To change between functions, depress the unlocking button and OPERATION rotate the selector to the desired operating mode.
CORDLESS ROTARY HAMMER DRILL WORKING HINTS FOR YOUR TOOL pack for a prolonged time will reduce the battery pack working time. This can be corrected after several If your power tool becomes over heated, set the speed charge and discharge operations by charging & to maximum and run no load for 2-3 minutes to cool working with your drill.
Page 12
POSITEC AUSTRALIA PTY LTD ABN 14 101 682 357 MADE IN PRC...
Need help?
Do you have a question about the RD2990.9 and is the answer not in the manual?
Questions and answers