Tao Motor Cheetah Owner's Manual page 22

4) Check the electrolyte flow. Keep the container in place for 20 minutes or longer until
it empties completely. If no air bubbles are coming up from the filler ports or if the
container cells haven't emptied completely after 20 minutes, then tap the container
and/or battery case gently a few times to cause the electrolyte to flow into the battery.
Do not remove the acid container from the battery until it is completely empty. The
battery requires the entire electrolyte from the container for proper operation.
5) Carefully remove the empty electrolyte container from the battery. Fully insert the strip of
sealing caps (previously removed from the electrolyte container) into the battery filling
ports. Make sure the strip of caps is fully inserted and flush with the top of the battery.
Insert the caps by hand, do not use a hammer or excessive force.
Never remove the strip of caps or add
water or electrolyte to the battery during its
service life.
6) For batteries with ratings of less than 18 AH, let the battery stand for 20 to 60
minutes. For batteries with higher AH ratings or having the High-Performance rating
(designated by an "H" in the part number/name), allow the battery to stand for 1 to
2 hours. Batteries have amp hour (AH) printed on the front of the battery case. The
stand or rest period allows the electrolyte to permeate into the plates for optimum
performance.
22