QubicaAMF Highway 66 User Manual page 149

INSTALLATION
Once all panels are installed, install the black plastic block in the gutter at the approach.
At this time, install the plastic molding at the back of the lane in the pit area.(See diagram IN-H66-039-010 page A-
164). That molding must be flush with the top of the lane, make any necessary adjustments.
Step 9
Capping and Ball Return Installation
See Diagram IN-H66-039-008 page A-162
Install the ball return common plank. (Item #1)
Install the small capping 2 ¾" (Item #6), start with the short section (Item #5) in front of the kickback.
Install the short capping on the front of the kickback (see detail A)
Install the ball return capping as show in detail B of the diagram.
Insert all decorative molding in both the ball return and in the 2 ½" capping.
At the foul line in the ball return capping, the decorative molding must be cut in order to make space for the tunnel
bracket. See diagram IN-H66-039-013 page A-168 detail A, for the exact dimension of the trim.
Install the ball detector and their reflector as show in detail C of the diagram.
Step 10
Masking Unit Installation
Start by installing the masking unit post; refer to diagram IN-H66-039-011 page A-166 for the position of these
posts.
Look at detail C for fixing the post.
Refer to diagram IN-H66-Q100-4500 page A-174 and IN-H66-122-4600 page A-175 for the detailed assembly of
the masking unit.
Install the Pit Lights fluorescent as show in Detail A in diagram IN-H66-MEB03-001 page A-176
Step 11
Ball Rack Installation
Refer Drawing IN-H66-039-013 page A-168 and IN-H66-122-3000-R1 page A-172.
Assembly the ball rack as show in diagram IN-H66-122-3000-R1, but at this time doesn't install the drop
track (Item #6), the ball cover (item #4) and the tunnel (Item #5).
Place the assembly perfectly inline with the ball return and perfectly center with on the approach, drill pilot
holes at the bottom of the drop at the foul line. Trace the inside of the hood with a pen that trace will guide
you for the installation of the wooden consol positioning plate (Item #7 of drawing IN-H66-039-013).
Remove the ball rack and fix the wooden consol positioning plate at the position you had trace before.
Install the ball rack at his place and use screw item #13 and 14 of drawing IN-H66-122-3000-R1 so secure
it in place. Once the ball rack is fix in place, install the molding (Item #1 of drawing IN-H66-039-012
page A-167) that cover the gap under the ball rack between the approach panel.
Install the drop track (Item #6) and the ball cover (Item #4) as show in diagram IN-H66-122-3000-R1.
Install the two bottom ball rack tunnel bracket on the ball return capping at the foul line as show in detail A
149