QubicaAMF Highway 66 User Manual page 146

Step 3
Approach Frame Installation Refer to Drawing IN-H66-039-002 page A-154
At the end of the last lane frame of each lane, screw the approach support (Item #1) using 8 #10 x 2 ½" screw, refer at
detail A of the drawing IN-H66-039-002 page A-154. Layout the approach frame of the first lane square with lane B
and A, layout the other approach frame be sure to respect distance between each frame.
Install the Link approach to lane (Item #6) before you fixed them, be sure to have 8' (2438mm) from the edge of the
lane frame and the end of the approach frame, if necessary leave space between the two.
Once you have the entire approach frame fixed with the lane frame, install the common approach filler (Item #5 #3 #2
#4).
Important:
If you install more than one unit Refer to Step 15 and Diagram IN-H66-039-025 and 026 Page A-170 for
installation of the union kit.
Step 4
Kickbacks and Pit installation
Refer Diagram IN-H66-039-003 page A-Error! Bookmark not defined.
Install the kickbacks as show in the diagram, at the same time install the left and right pit support (Item #1 and 2) and
the Double kickback pit support (Item #3). Adjust the height of the leveling foot to support the kickbacks.
At this time you should run the wires from the pinsetter area to the front ball rack and to the monitors post.
Step 5
Machines and Pit Installation
Refer Diagram IN-H66-039-004 page A-156
Install the flat gutter (Item #16) using 6 #10 x 1 ½".
Install the ball return start plank; follow by the ball return common plank. (Item #3 and 4)
Install the main cross support for the machine (Item #12)
Install the front kickback panel (Item #2)
Install the ball track frame assembly (Item #5)
Install the elevator side bracket (Item #13)
Install the elevator kickback panel (Item #1) refer to detail A of the IN-H66-039-004.
Refer Diagram IN-H66-039-005A page A-Error! Bookmark not defined.
Install the pit frame assembly (Item #4) and secure it in place using the pit retaining bracket (Item #1).
Install the elevator; note that you have to remove the rear cover of the elevator in order to install it.
Install the two special capping in front of the kickback (Item #12 and 13)
Assemble the drop track using item #2 and 3 and install as show in the drawing.
Install the ball protector as per detail A and B in drawing IN-H66-039-010B on page A-165
Assemble the elevator motor as show in drawing IN-H66-039-005B page A-158
Install the machine on their support; refer at drawing IN-H66-MEB03-001 and IN-H66-MEB03-002 page A-176
and A-177
146