Release Notes; Installation; Upgrades; New Installs - Nortel INM 3.1 Release Note

Release Notes

1. Installation

It is strongly recommended that users read and understand the installation
procedures in the User Guide before installing INM Broadband.

Upgrades

INM Broadband 3.1 runs only on HP-UX 10.10/10.20. Therefore existing
workstations running versions of HP-UX operating system earlier than
HP-UX 10.10 must be upgraded to HP-UX 10.10 or HP-UX 10.20 before
running INM Broadband 3.1 software.
To upgrade a workstation running S/DMS Network Manager Release 4, 5 or 6
on a HP-UX 9.05 operating system, the following steps are required:
•
•
•
•

New Installs

1 When an alternate directory other than /opt/nortel (default in INM 3.1) is

2. Federated Networks

It is strongly recommended that users read and understand the Federated
Networks User Guide before installing INM Broadband.
1 When a Client is indirectly monitoring both Primary and Backup
INM Release 3.1 Release Notes
Save the configuration of the previous S/DMS Network Manager
workstation using the "Transferring the configuration database" procedure
in the INM Broadband GUI User Guide.
Upgrade the HP-UX operating system to 10.10 or 10.20.
Install INM Broadband 3.1 software using the "Installing the INM
Broadband GUI software" procedure in the INM Broadband GUI User
Guide.
Restore the configuration previously saved using the "Transferring the
configuration database" procedure in the INM Broadband GUI User
Guide.
selected, the user will get this misleading error message which can be
ignored: "/opt/nortel was not found".
controllers through the same server, and if any one of the controllers
(primary or backup) is deleted from the server, this causes a promotion on
13 of 24
Issue 1.0