Paradyne HotWire 5446 Installation Instructions Manual page 13

LED Symptom
PWR LED is off.
TST LED is on.
5446 RTU IP Setup
The 5446 RTU hardware installation is now complete. Additional steps are required by
the NSP to utilize the DSL and Ethernet connections.
Network Service Provider Example
The ISP:
Assigns and sets up the RTU IP address and subnet mask.
Assigns the IP address and subnet mask for each end-user system connected to
the 5446 RTU.
The following is used to configure the end-user system:
IP address
Subnet mask
Default gateway
The 5446 RTU is the default gateway for all connected end-user systems.
Example using TCP/IP Network Settings with Windows 95:
Set up the network configuration. Use the network settings in the Windows environment
to enter the default gateway, IP address, and subnet mask.
1. To configure the end-user system, from the Control Panel window, select:
Network
2. From the TCP/IP Properties window, select Gateway and enter the 5446 RTU's
IP address.
3. From the IP Address window, enter the IP Address and Subnet Mask. Select OK.
NOTE:
Any application supported by the NSP should now start up.
Action
Check that the power cord is securely installed on both ends.
If no LEDs are on, the power supply may be defective. Try a
different outlet to test the power supply. If problem persists,
contact the NSP.
If other LEDs are on, the PWR LED may be burned out. Unplug
the unit and reapply power; watch all LEDs during the power-on
self-test to verify that the PWR LED is functioning.
A test initiated by the NSP may be active. Wait five minutes. If
the TST LED does not go off, contact the NSP.
Configuration TCP/IP
13