Paradyne HotWire 5446 Installation Instructions Manual page 10

3. Place the supplied ferrite
choke on the Ethernet
cable as closely as possible
to the RTU. Pass the
Ethernet cable through
the ferrite choke twice,
creating a loop as shown.
4. Close the two halves
around the cable and
snap the ferrite choke
shut. Press down on the
plastic latch to secure
the ferrite choke in place
around the cable.
5. Insert the power cord's round end into the jack labeled POWER. Plug the
transformer into an AC outlet.
The following illustration displays examples of two power supply models.
Power
Jack
or
Transformer
The RTU hardware installation is now complete. When the power cord is installed, the
RTU goes through a power-on self-test.
HotWire RTU
HotWire RTU
or
10
496-14952
Ethernet
Line
Ferrite
Choke
97-15303a
97-15626