Nortel Call Recording Card User Manual page 37

September 2007
Connecting the Nortel Call Recording Card to a modem
To provide remote access to the Command Line Interface (CLI) for support
and remote maintenance, you can connect a modem to the serial port of the
Nortel Call Recording Card. To set up a working interface, perform the
following procedure:
1 Using a standard serial cable, establish communication with the Hayes-
compatible modem from a PC with the following settings: 9600 baud, 8
data bits, 1 stop bit, no parity, and no flow control.
2 From the command line, type the following:
AT <return>
3 At the OK prompt, enter the required settings from Table 8: "Modem
settings," on page 37.
Table 8:
Setting
ASSO=1<return>
ATQ1 <return>
ATE0<return>
AT&W0<return>
4 Use the 9-pin connector on the card adapter (L-adapter) to connect the
modem to the Nortel Call Recording Card.
Planning, Installation, and Administration Guide
Modem settings
Action
set to auto-answer on first ring
disable result codes
disable local echo
save settings
Configuring the Nortel Call Recording Card
37