Page 1
WE-EF LEUCHTEN Installation and Maintenance Instructions Pendant luminaire ALP534 LED AOP534 LED Surge Protection This product features built-in surge protection circuitry in compliance with applicable standards. For comprehensive protection of a luminaire installation against lightning and electrical surges, it is essential to cover mains supply and data input lines at the distribution board level, by using respective primary (Type 1) and secondary (Type 2) surge arrestors in compliance with EN61643-11/IEC61643-1.
Page 2
Pendant luminaire ALP534 AOP534 ø 560 ø 560 IP55, Class I, ta = 25°C...
Light Source Maintenance Apart from cleaning the product’s exterior surfaces, no special maintenance work is required. Do not use high-pressure cleaners. In case of component failure due to abnormal circumstances or at end of life, replacement must be carried out Warning: Do not open luminaire while mains supply is switched on.
Installation Installation Procedure The product must be installed and maintained by a 1) Switch off the mains electrical supply. 2) Check that the rating shown on luminaire label building/construction and/or electrical regulations and conforms with mains electrical supply. relevant legislation. 3) Loosen screws A of the cover B.