Prerequisites - Nortel Secure 4134 Installation Manual

64 Installing Secure Router 4134 hardware components

Prerequisites

•
•
Procedure steps
Step
1
2
3
4
Copyright © 2007, Nortel Networks
.
CAUTION
Do not open the Secure Router 4134 service access panel while
the unit is powered.
Ensure you have a replacement DIMM.
Ensure you have a Phillips #2 screwdriver.
Action
Remove the two screws at the rear of the Secure Router 4134 that
hold the service access panel secure. The following figure shows
the two screws that you must remove.
Slowly slide the access panel toward you until it is clear of the
Secure Router 4134.
Locate the DIMM module.
Release the latches that secure the DIMM in the slot.
There is a release latch at both ends of the DIMM slot. See the
following figure.
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 01.02 Standard
10.0 7 August 2007