Advertisement
5. Install the SMPTE and MIDI interfaces
-
Install the 2 interfaces with the screws and washers that were removed in the previous step.
6. Connect cabling:
-
Connect the USB cable coming from the front panel
-
Connect the interface interconnect cable
7. Test the interface.
-
Before closing the controller, test the interfaces (see chapter 5)
8. Close the controller when the test was successful.
-
Close the controller in reverse order of opening.
PLEASE NOTE that the dimmer plate and power switch plate are on the inside of the controller when you place the
front panel on the base. Forced closing when the 2 plates are not in the correct position can damage the dimmer wheel
of the desk lamp and/or the power switch!!!
Page 8
Advertisement
